In one of our previous articles discussed about the different types of furniture hinges, today I’ll tell a little about how to properly Prisada facade under these same loop. Included in the above article ‘Furnitura.Kaie are furniture hinges. ” it was suggested that the installation of loops in the front need to drill Forstner diameter of 35 mm. but said nothing about where in front of the building needs to be done is to deepen for a loop. There are some standards I’ll show you on the schematic drawings with little explanation. Let’s start with the question of whether, and in general how many holes should I do? How long does it hinge on the facade on the basis of its size and weight?
1) shows generally accepted standards for placement of the loop. As expected, the larger the size and weight of the facade the more loops to it to establish the reliability of designs, such as for wooden facades of the array compliance with the required number of loops to avoid the deformation front (as quadrupeds tree that may eventually lead from moisture or vice versa ). Now, about where and how to drill. Figure 2 shows in his left Part schematically depicts a facade with the dimensions of furniture under the additive. The size is designated as X, in principle, can be arbitrary, but the most common fronts with marking this distance equal to 10.11 cm in the example in furniture Ikea (Ikea) this distance is 5 cm, but if the distance for us is not fundamental, then all the other dimensions must be strictly soblyusti.Razmechaem point which will be the focus of our openings on the horizontal edge facade measures off a distance X = 110 mm and the vertical edges 22 mm.